Diamond-ground preparation
We mechanically grind the slab to open the concrete profile. Acid etching alone is the most common reason a coating peels within a year.
Epoxy Garage Floor Coating in Orlando, FL
A garage floor in Central Florida takes a beating that floors up north never see: slab moisture pushing up from below, afternoon heat, and hot tires that lift a cheap coating right off the concrete. Most failed epoxy floors we're called to fix didn't fail because of the epoxy — they failed because nobody prepped the slab or tested it for moisture first.
Evercrest Construction Group is a licensed and insured contractor based in Orlando, serving Orlando, FL 32824 and the surrounding communities. Every job starts with a written scope and one clear price — not a verbal estimate that grows once work begins.
What’s included
Moisture testing before we quote
Florida slabs sit on damp sand. We test for vapor drive first, because a coating installed over a wet slab will bubble no matter how good the product is.
Crack and spall repair
Control joints, pitting and chips get filled and leveled before any coating goes down, so you don't see them telegraphing through the finish.
Full broadcast flake or solid color
Decorative vinyl flake for chip-hiding texture and grip, or a clean solid color. Both sealed with a UV-stable polyaspartic topcoat.
Hot-tire resistant topcoat
Rated for vehicle traffic in Florida heat — this is where big-box DIY kits fail first.
Written warranty
Delamination and peeling coverage in writing, with the scope and product data sheets attached to your contract.
Epoxy Garage Floor Coating across the Orlando area
We work throughout Orlando and Central Florida, including Meadow Woods, Southchase, Hunter's Creek, Lake Nona, Buenaventura Lakes, Kissimmee, Conway, Belle Isle, Dr. Phillips, Winter Garden, Ocoee, Apopka and the rest of Orange and Osceola County. Our crews regularly serve ZIP codes 32824, 32821, 32827, 32832, 32837, 32809, 32812, 32819, 32822 and 32829.
Not sure whether we cover your address? Call 407-413-8886 and we’ll tell you straight — we’d rather say no than take a job we can’t service properly.
Frequently asked questions
How much does an epoxy garage floor cost in Orlando?
Most residential two-car garages fall in a predictable range once we know the square footage, the slab's condition, and whether you want flake or solid color. We measure on site, test the slab, and give you one written number before any work starts — no allowances that move later.
How long does it take?
A typical two-car garage is a two-day job: grinding and repairs on day one, coating and topcoat on day two. You can usually walk on it after 24 hours and park on it after 72.
Will it peel like my last one?
Not if the slab is prepared properly. Peeling is almost always a preparation failure — acid etching instead of grinding, or coating over a slab with active moisture. We grind and moisture-test on every job, and warranty the result in writing.
Do you coat commercial and warehouse floors?
Yes. Shops, warehouses, showrooms and multi-bay facilities throughout Orlando. Larger floors are scheduled around your operating hours.
Request a free quote
Tell us about your project and we’ll come measure it. You’ll get a written scope and one number — and if we’re not the right company for the job, we’ll say so.